sdc asked in Q&A:
When I saw
” Invalid system disk?
Disk 1/0 error?
Replace the disk, then press any key”
I asked u people. U sujested to replace Hard drive. I replaced with a same GB H disk& pressed one key, but It says ” primary hard disk drive 0 not found” when i pressed F1 as it said, I could see “3com PXE, Version 0.99j.02
copyright (c) 1997,1998 Intel corporation, all right reserved.
(c)copyright 1998 LAN works TEC: CO:
a subsidary of 3com corp:
after a while
PXE-E61: media test failure, check cable.
PXE-M0F: exiting PXE
if i press F1 i will get the same message, F2 takes me to the set up utility(windows 98, intel,P2, 4.2 GB H disk)
when i use the old ( reportedly crashed) H disk, in the setup, in the boot sequense we can see a sign like ‘J’ attached with a sign(-) on the top IE ….{J1.Hard disk drive C: J2. PXE}
but with the new H disk-in the boot sequence-only {J2. PXE}. I cant replce now Floppy drive & CD financially if so, can I do it all with an other PC (Xp)?
When I saw
” Invalid system disk?
Disk 1/0 error?
Replace the disk, then press any key”
I asked u people. U sujested to replace Hard drive. I replaced with a same GB H disk& pressed one key, but It says ” primary hard disk drive 0 not found” when i pressed F1 as it said, I could see “3com PXE, Version 0.99j.02
copyright (c) 1997,1998 Intel corporation, all right reserved.
(c)copyright 1998 LAN works TEC: CO:
a subsidary of 3com corp:
after a while
PXE-E61: media test failure, check cable.
PXE-M0F: exiting PXE
if i press F1 i will get the same message, F2 takes me to the set up utility(windows 98, intel,P2, 4.2 GB H disk)
when i use the old ( reportedly crashed) H disk, in the setup, in the boot sequense we can see a sign like ‘J’ attached with a sign(-) on the top IE ….{J1.Hard disk drive C: J2. PXE}
but with the new H disk-in the boot sequence-only {J2. PXE}. I cant replce now Floppy drive & CD financially if so, can I do it all with an other PC (Xp)?
….floppy disk….windows 98
what are those
:p
j/k